AMETEK MX CTSH - Manual (Page 47)

California Instruments
User Manual
3.7.2 Installing the PCI Card Driver
Insert the CIC651 in the CD ROM
configured for AutoStart. If not, double click on the Setup.exe
Select the CI401PCI / CI403PCI
Follow the installation prompts
If your system was supplied with
Rom instead.
3.7.3 Installing the PCI A/D Card
Following the procedure outlined
1. Disconnect your PC from any main power.
2. If possible, wear a grounded
the PC cabinet on a firm ESD
3. Remove the cover of the
4. Locate the PC’s PCI bus
5. Using a suitable screwdriver
in step 4. The A/D card has
your own discretion. You
6. Carefully remove the PCI card from its protective bag and hold it along the top edge.
touch the gold finger edge
7. Insert the card carefully in
of the PC. Press down firmly
in the PCI slot connector.
connector.
8. Install the screw you removed
9. If you plan to use an IEEE
one in the host PC yet, now would be
instructions for installation.
10. Replace the PC’s cover following
Revision H
MX Series CTSH Compliance
Driver Software
ROM drive. The setup.exe program should start if
configured for AutoStart. If not, double click on the Setup.exe program to launch
CI403PCI Card Driver Installation and click on the Run Setup
prompts for the Driver installation to install the A/D Card
with a NI PCI-6034E card instead, install the card
outlined below to install the PCI card in the test system PC:
Disconnect your PC from any main power.
grounded wrist strap to prevent ESD damage to the PC
ESD safe working surface.
PC cabinet following the directions provided by the PC manufacturer.
expansion slots. The CI400PCI requires a single
screwdriver (typically Phillips #2), remove the cover plate
has its own cover plate so the one you remove may
You will need to re-use the screw however, so make
Carefully remove the PCI card from its protective bag and hold it along the top edge.
edge connectors at the bottom.
in the selected slot making sure the DB68 connector
firmly along the top edge of the board to make sure
It may help to rock the board gently or start from
removed in step 5 and secure the PCI board to the PC slot by its cover plate.
IEEE-488 Controller to communicate with the AC Source
one in the host PC yet, now would be a good time to do so. Follow the Bus
installation.
following the directions provided by the PC manufacturer.
47
Compliance Test System
if the CD ROM drive is
launch the installation wizard.
Setup button.
drivers.
drivers from the NI-DAQ CD
the PCI card in the test system PC:
PC and the A/D Card and place
the PC manufacturer.
single 32 bit PCI slot.
for the slot you opted to use
may be saved or discarded at
sure you do not loose it.
Carefully remove the PCI card from its protective bag and hold it along the top edge. Take care not to
connector clears the slot in the back
sure the board is seated properly
from one end of the edge
the PCI board to the PC slot by its cover plate.
Source and have not installed
Bus Controller manufacturer’s
manufacturer.