AMETEK MX CTSH - Manual (Page 48)

California Instruments
User Manual
3.7.4 Testing the PCI Card
MXCTSH must be installed first
must be rebooted. The new hardware
operating system. Follow the
Note: When connecting the high
align the cable plug with
should insert easily. If undue force is needed, the
pins may be bent. Check the plug
the PACS-3-75 and the
NI E-Series DAQ Board
Once the PCI A/D card is installed
Automation” icon on the desktop.
now see the PCI card you installed
NI M-Series DAQ Board
Launch Measurement and Automation,
Select “Self-Test” and you should
Revision H
MX Series CTSH Compliance
first before performing a A/D card testing. After MXCTSH is
hardware should be detected automatically at boot
the on-screen prompts to finish installation of the A/D card.
high density 68 pin connector to the back of the A/D
with the A/D card connector carefully so as not to bent
If undue force is needed, the plug may not be aligned
be bent. Check the plug and connector carefully before installing
the PC.
installed and the PC has been re-booted, you should
desktop. Double click on it and expand the Devices and
installed as shown in the screen below.
Automation, select NI-DAQmx Devices, NI PCI-6250: “Dev1”.
should get the pop-up message below.
48
Compliance Test System
MXCTSH is installed, the PC
boot by the Windows™
to finish installation of the A/D card.
A/D card in the PC, make sure to
bent any pin. The connector
not be aligned properly or one or more
installing the supplied cable between
should see a “Measurement and
and Interfaces tree, you will
6250: “Dev1”.