AMETEK Ls Series Driver Manual - Manual (Page 65)

IVI Driver Manual Lx / Ls Series
61
Pass whether you want to enable or disable the OVP limit. The
driver uses this value to set the CILXS_ATTR_OVP_ENABLED attribute.
Valid Values:
VI_TRUE (1) - Enable OVP limit
VI_FALSE (0) - Disable OVP limit
Default Value: VI_TRUE
limit
Variable Type ViReal64
Pass the over-voltage protection limit you want to use for the
specified phase. The driver uses this value to set the
CILXS_ATTR_OVP_LIMIT attribute.
Units: volts
Valid Range:
0.0 to 500.0
Default Value: 500.0 volts
Return Value
Returns the status code of this operation. The status code either
indicates success or describes an error or warning condition. You
examine the status code from each call to an instrument driver
function to determine if an error occurred.
To obtain a text description of the status code, call the
ciLxs_error_message function. To obtain additional information about
the error condition, call the ciLxs_GetError function. To clear the
error information from the driver, call the ciLxs_ClearError
function.
The general meaning of the status code is as follows:
Value Meaning
-------------------------------
0 Success
Positive Values Warnings
Negative Values Errors
This driver defines the following status codes:
Status Description
-------------------------------------------------
ERRORS:
BFFA1001 The trigger source is not software trigger.
This instrument driver also returns errors and warnings defined by
other sources. The following table defines the ranges of additional