AMETEK Ls Series Driver Manual - Manual (Page 209)

IVI Driver Manual Lx / Ls Series
205
Variable Type ViInt32
Pass the desired harmonic number. Queries sent with a value of 0
return the dc component. A value of 1 returns the fundamental output
frequency. Harmonic orders can be queried up to the fundamental
measurement bandwidth of the measurement system,
which is 12.6kHz. Thus the maximum harmonic that can be measured is
dependent on the output frequency. Any harmonics that represent
frequencies greater than 12.6kHz are returned as 0.
Default Value: 1
measurementType
Variable Type ViInt32
Pass the measurement you want the power supply to take.
Defined Values:
CILXS_VAL_HARMONIC_VOLTAGE_AMPLITUDE - Voltage Amplitude
CILXS_VAL_HARMONIC_VOLTAGE_PHASE - Voltage Phase
CILXS_VAL_HARMONIC_CURRENT_AMPLITUDE - Current Amplitude
CILXS_VAL_HARMONIC_CURRENT_PHASE - Current Phase
CILXS_VAL_HARMONIC_NEUTRAL_CURRENT_AMPLITUDE - Neutral Current
Amplitude
CILXS_VAL_HARMONIC_NEUTRAL_CURRENT_PHASE - Neutral Current Phase
Default Value: CILXS_VAL_HARMONIC_VOLTAGE_AMPLITUDE
measurement
Variable Type ViReal64 (passed by reference)
Returns the measured value.
Return Value
Returns the status code of this operation. The status code either
indicates success or describes an error or warning condition. You
examine the status code from each call to an instrument driver
function to determine if an error occurred.
To obtain a text description of the status code, call the
ciLxs_error_message function. To obtain additional information about
the error condition, call the ciLxs_GetError function. To clear the
error information from the driver, call the ciLxs_ClearError
function.
The general meaning of the status code is as follows:
Value Meaning
-------------------------------
0 Success
Positive Values Warnings