AMETEK Ls Series Driver Manual - Manual (Page 227)

IVI Driver Manual Lx / Ls Series
223
ciLxs_reset
ViStatus ciLxs_reset (ViSession instrumentHandle);
Purpose
This function resets the instrument to a known state and sends
initialization commands to the instrument. The initialization commands
set instrument settings such as Headers Off, Short Command form, and Data
Transfer Binary to the state necessary for the operation of the
instrument driver.
Parameter List
instrumentHandle
Variable Type ViSession
The ViSession handle that you obtain from the ciLxs_init or
ciLxs_InitWithOptions function. The handle identifies a particular
instrument session.
Default Value: None
Return Value
Returns the status code of this operation. The status code either
indicates success or describes an error or warning condition. You
examine the status code from each call to an instrument driver
function to determine if an error occurred.
To obtain a text description of the status code, call the
ciLxs_error_message function. To obtain additional information about
the error condition, call the ciLxs_GetError function. To clear the
error information from the driver, call the ciLxs_ClearError
function.
The general meaning of the status code is as follows:
Value Meaning
-------------------------------
0 Success
Positive Values Warnings
Negative Values Errors
This driver defines the following status codes:
Status Description
-------------------------------------------------
ERRORS:
BFFA1001 The trigger source is not software trigger.
This instrument driver also returns errors and warnings defined by
other sources. The following table defines the ranges of additional
status codes that this driver can return. The table lists the