AMETEK Ls Series Driver Manual - Manual (Page 111)

IVI Driver Manual Lx / Ls Series
107
delays. As each dwell delay elapses, the next point is immediately
output.
CILXS_VAL_TRIGGER_LIST_STEP_AUTO - causes the list to advance only
one point after each trigger. Triggers that arrive during a dwell
delay are ignored.
Default Value: CILXS_VAL_TRIGGER_LIST_STEP_AUTO
listSize
Variable Type ViInt32
The size of the array of dwell times.
dwellTimes
Variable Type ViReal64[]
This parameter sets the sequence of list dwell times. Each value
represents the time in seconds that the output will remain at the
particular list step point before completing the step. At the end of
the dwell time, the output of the depends upon the following
conditions:
* If step mode parameter has been set to
CILXS_VAL_TRIGGER_LIST_STEP_AUTO, the output automatically changes to
the next point in the list.
* If step mode parameter has been set to
CILXS_VAL_TRIGGER_LIST_STEP_ONCE, the output remains at the present
level until a trigger sequences the next point in the list.
The order in which the points are entered determines the sequence in
which they are output when a list is triggered. Changing list data
while a subsystem is in list mode generates an implied "abort".
repeatTimes
Variable Type ViInt32[]
This parameter sets the sequence of list repeat times. Each value
represents the time in seconds that the output will repeat at the
particular list step point.
Return Value
Returns the status code of this operation. The status code either
indicates success or describes an error or warning condition. You
examine the status code from each call to an instrument driver
function to determine if an error occurred.
To obtain a text description of the status code, call the
ciLxs_error_message function. To obtain additional information about
the error condition, call the ciLxs_GetError function. To clear the
error information from the driver, call the ciLxs_ClearError