AMETEK Compact IX 2253 - Manual (Page 35)

User Manual 2253i / 2253iX
AMETEK California Instruments 35
3.3.2 Rackmount
If the power source is to be mounted in a cabinet system, proper supports such as rack slides,
brackets or a shelf must be provided to support the weight of the unit along its depth. The rack ears on
the front of the power source are not intended to support the entire weight of the unit and should only
be used to prevent the unit from sliding forward.
Contact the cabinet manufacturer for suitable rack support accessories. Extendable rack slides for
24”-28” deep cabinets are available from AMETEK Programmable Power. (-RMS option). The rack
mount slide mounting holes centerlines on the side of the power source are 2.30 inches / 58.4 mm
above the bottom edge of the front panel.
Figure 3-1: Rack Mount Slides (-RMS option) position