AMETEK Compact IX 2253 - Manual (Page 101)

User Manual 2253i / 2253iX
AMETEK California Instruments 101
7.3.3 Overload Light is On
CAUSE SOLUTION
Unit is overloaded Remove overload or check CL setting
Unit is switched to high voltage range. Select correct voltage range.
7.3.4 Distorted Output
CAUSE SOLUTION
Power source is grossly overloaded. Reduce load
The crest factor of the load exceeds 3:1. Reduce load current peaks by reducing
load.
7.3.5 No Output and No Lights on Front Panel
CAUSE SOLUTION
Input switched off. Switch unit on.
No input power. Ensure power is present at AC input
terminal block.
Incorrect input voltage Voltage applied to a unit is outside of
allowable input voltage range. Check
model number tag on unit for required
input voltage.
7.3.6 No Output But Front Panel controller is active
CAUSE SOLUTION
“OUTPUT ON” button is turned off. Press OUTPUT ON so that “ON” LED is
lit.
Current limit programmed down or to zero. Program current limit higher.
Voltage programmed down or to zero.
Turn amplitude control up.