Sdi audio ip interface signals, Sdi audio embed signals, Sdi audio ip interface signals -1 – Altera SDI Audio IP Cores User Manual
Page 21: Sdi audio embed signals -1
4
SDI Audio IP Interface Signals
2014.06.30
UG-SDI-AUD
SDI Audio Embed Signals
The following tables list the signals for the SDI Audio Embed IP cores.
This table lists the general input and output signals.
Table 4-1: SDI Audio Embed General Input and Output Signals
Description
Direction
Width
Signal
This signal resets the system.
Input
[0:0]
reset
This signal provides the frequency reference used when detecting
the difference between video standards using 1 and 1/1.001 clock
rates. If its frequency is 0, the signal only detects either one of the
clock rates.
The core limits the possible frequencies for this signal to 24.576
MHz, 25 MHz, 50 MHz, 100 MHz, and 200 MHz. Set the required
frequency using the Frequency of fix_clk parameter.
Input
[0:0]
fix_clk
If you set the Frequency of fix_clk parameter to 0, you must drive
this signal high to detect a video frame rate of 1/1.001 and low to
detect a video frame rate of 1. For other settings of the Frequency
of fix_clk parameter, the core automatically detects these frame
rates and drives this signal low.
Input
[0:0]
vid_std_rate
The 48 kHz output clock that is synchronous to the video. This
clock signal is only available when you turn on the Frequency Sine
Wave Generator or Include Clock parameter.
Output
[0:0]
vid_clk48
This table lists the video input and output signals.
©
2014 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, ENPIRION, MAX, MEGACORE, NIOS, QUARTUS and STRATIX words
and logos are trademarks of Altera Corporation and registered in the U.S. Patent and Trademark Office and in other countries. All other
words and logos identified as trademarks or service marks are the property of their respective holders as described at
www.altera.com/common/legal.html
. Altera warrants performance of its semiconductor products to current specifications in accordance with
Altera's standard warranty, but reserves the right to make changes to any products and services at any time without notice. Altera assumes
no responsibility or liability arising out of the application or use of any information, product, or service described herein except as expressly
agreed to in writing by Altera. Altera customers are advised to obtain the latest version of device specifications before relying on any published
information and before placing orders for products or services.
www.altera.com
101 Innovation Drive, San Jose, CA 95134