EXFO FLS-2600B Tunable Laser Source - Manual (Page 81)

Remote Control
Tunable Laser Source 73
Changing the Baud Rate for RS-232
Changing the Baud Rate for RS-232
To change the baud rate for RS-232 transfer, you must be in RS-232 mode.
To select RS-232 mode, see Setting the FLS-2600B for Remote Control on
page 71.
To change the baud rate:
1. Press Setup.
2. Turn the selection dial clockwise until BAUD is displayed. The current
setting appears.
3. Press ENTER. The Edit marker starts blinking in the lower part of the
display.
4. Turn the selection dial to enter the rate you wish to work with.
5. Press ENTER.
6. To exit the Setup menu, press Setup.
Edit