Source:sweep:repeat – EXFO FLS-2600B Tunable Laser Source User Manual
Page 108
Remote Control
100
FLS-2600B
Specific Commands
SOURce:SWEep:REPeat
Description This command is used to specify how many times you want the
sweep program to repeat.
Syntax
SOUR:SWE:REP
Parameters The
whether or not the sweep program will be repeated:
1: the sweep program will be repeated continuously.
0: the sweep program will be repeated for the number of
times set by the SOUR:SWE:COUN command.
Example
SOUR:SWE:REP 1
Note
You cannot use this command during a sweep.
See also
SOUR:SWE:MODE, SOUR:SWE:MODE?, SOUR:SWE:CENT,
SOUR:SWE:COUN, SOUR;SWE:COUN?, SOUR:SWE:REP?,
SOUR:SWE:REV and SOUR:SWE:REV?
SOURce:SWEep:REPeat?
Description This query is used to check how the sweep repeat function is
activated.
Syntax
SOUR:SWE:REP?
Response
A boolean value indicating the state of the sweep repeat
function:
1: the sweep repeat function is continuous.
0: the sweep repeat function is set to the number entered
with the SOUR:SWE:COUN command.
See also
SOUR:SWE:MODE, SOUR:SWE:MODE?, SOUR:SWE:CENT,
SOUR:SWE:COUN, SOUR;SWE:COUN?, SOUR:SWE:REP,
SOUR:SWE:REV and SOUR:SWE:REV?