EXFO FLS-2600B Tunable Laser Source - Manual (Page 146)

Remote Control
138 FLS-2600B
FLS-2600B Error and Warning Messages
61 A problem occurred with the
thermo-electric cooler.
Contact EXFO.
62 The Flash memory was not
detected by the tunable laser
source.
Contact EXFO.
63 The Flash reading was not
performed in the set delays.
Contact EXFO.
64 The EEPROM was not
detected.
Contact EXFO.
65 A checksum error was
detected by the Tunable
Laser Source.
Contact EXFO.
66 A problem occurred while
the motor was moving.
Contact EXFO.
67 The Tunable Laser Source
index was lost.
Restart the Tunable Laser
Source.
68 The Tunable Laser Source is
outside its temperature
settings.
Ensure that the ambient
temperature is within the
Tunable Laser Source’s range.
69 An FPGA problem was
detected.
Contact EXFO.
71 An error occurred during a
sweep.
Retry your sweep.
72 An EEPROM error has been
detected.
Contact EXFO.
100 A command could not be
added to the command pipe.
Avoid turning the selection dial
while the Tunable Laser Source
is performing a sweep.
Error or
warning
Number
Description Recommended Action