EXFO FLS-2600B Tunable Laser Source - Manual (Page 127)

Remote Control
Tunable Laser Source 119
Programming Commands
Note You cannot use this command while the FLS-2600B is performing
a sweep.
You do not have to enter all values in the command, but you must
enter the values in the same order as in the Syntax section. If you
want to enter only some of the values, use a comma ( , )
to separate the values, including the ones you did not enter.
For each value including units, such as wavelengths or speed,
you can specify a unit to use in the same way as the specific
commands in the previous pages. If you do not specify the units,
the system will use those that are currently set.
To specify the units, add at the end of the value
you want to modify. The parameter will be a wavelength
unit (nm or THz) or a speed unit (nm/s or THz/s).
Examples A complete command:
SOUR:SWE:CONT:PROG 1550.50,1600.50,10.000,25,1,1
A command changing only the speed and reverse options:
SOUR:SWE:CONT:PROG ,,10.000,,0,
A command setting the start and stop wavelengths in THz, as
well as the speed in THz/s, leaving the latter at its original
settings:
SOUR:SWE:CONT:PROG 196.7 THZ,186.8 THZ,5.000 THZ/S
SOURce:SWEep:CONTinuous:PROGram