EXFO FLS-2600B Tunable Laser Source - Manual (Page 130)

Remote Control
122 FLS-2600B
Programming Commands
SOURce:SWEep:STEPped:PROGram
Description This function is used to set the parameters for a step-by-step
sweep program, during which the application sweeps between
two wavelengths, stopping at preset intervals.
Syntax SOUR:SWE:STEP:PROG[],[],
[], [],[],[],[]
Parameters The and parameters represent the start and
stop wavelengths for the sweep. The current spectral
measurement units apply (nm or THz). The format must be
9999.999 nm or 999.9999 THz.
The parameter is the pause length between the steps.
The format must be 59:999.
The parameter is the size of the step between the
measurements. The format will be 9999.999 nm or
999.9999 THz.
The parameter is the number of cycles to be
performed during the sweep. The format will be 1-99 or 0
(continuous).
The parameter indicates whether the reverse option is
on or off. The format must be 1/0.
The parameter indicates whether the trigger option is on
or off. The format must be 1/0.