EXFO FLS-2600B Tunable Laser Source - Manual (Page 20)

Getting Started with Your Tunable Laser Source
12 FLS-2600B
Turning on the Unit
Some internal mechanisms can sometimes take several seconds to adjust,
depending on the operation.
The front panel control provides access to the following options:

source activation/deactivation

Normal or High-Resolution mode

wavelength editing

shortlisted wavelengths

power editing

shortlisted wavelength addition or deletion

start and stop sweep
The blue buttons to the right of the display give access to single-level
menus: Sweep and Setup. Unless a sweep is under way, these menus can
always be accessed, even while the source is active. The following
diagram shows these two menus and their items.
To move between the menu items, turn the selection dial. To exit a menu,
press the button that gave access to it (Sweep or Setup). The FLS-2600B
will return to its previous state.
Note: The unit will beep whenever the FLS-2600B does not allow an operation.
DURATION
Sweep
Setup
START

STOP

MODE
STEP PAUSE
CYCLE REVERSE TRIGGER
UNIT REMOTE
DEVICE
DIMMER
SAVE RECALL
SPEED
BAUD FLOW
ADJUST SOUND