Calculate[1..n][:wdm]:state – EXFO FTB-5230S Optical Spectrum Analyzer for FTB 200 v2 User Manual
Page 536

Referencia de instrucciones SCPI
530
FTB-5240S/S-P/BP
Product-Specific Commands—Description
:CALCulate[1..n][:WDM]:STATe
Description
This command controls activation of WDM
analysis.
At *RST, WDM analysis is set to on (enabled).
Syntax
:CALCulate[1..n][:WDM]:STATe
Parameter(s)
Auto:
The program data syntax for
as a
on input for increased readability. ON
corresponds to 1 and OFF corresponds to 0.
The
state of WDM analysis.
0 or OFF: WDM analysis is disabled.
1 or ON: WDM analysis is enabled.
Example(s)
CALC:WDM:STAT ON
CALC:WDM:STAT? Returns 1 (WDM analysis
enabled)
Notes
WDM analysis cannot be disabled: OFF (0) value
is valid for queries only.
It is possible to query acquired trace data only if
active measurement analysis mode is WDM.
See Also
:CALCulate[1..n][:WDM]:STATe?
:INITiate[:IMMediate]
:INITiate:CONTinuous
:TRACe:FEED:CONTrol