ADLINK ReadyBoard 910 - Manual (Page 47)

ReadyBoard 910 Reference Manual 41
Chapter 4 BIOS Setup
Introduction
This section assumes the user is familiar with general BIOS Setup and does not attempt to describe the BIOS
functions. Refer to “BIOS Setup Menus ” on page 43 in this chapter for a map of the BIOS Setup settings. If
ADLINK has added to or modified any of the standard BIOS functions, these functions will be described.
Entering BIOS Setup (Local Video Display)
To access BIOS Setup using a local video display for the ReadyBoard 910:
1. Turn on the display and the power supply to the ReadyBoard 910.
2. Start Setup by pressing the [Del] key when the following message appears on the boot screen.
Press DEL to run Setup
3. Follow the instructions on the right side of the screen to navigate through the selections and modify any
settings.
Entering BIOS Setup (Serial Port Console)
This section describes how to enable the Serial Port Console in VGA mode and enter the BIOS setup
through a serial terminal or PC.
1. Turn on the power supply to the ReadyBoard 910 and enter the BIOS Setup Utility in VGA mode.
2. Set the BIOS feature Serial Port Console to [Enable] under the Advanced menu.
3. Accept the default options or make your own selections for the balance of the Serial Port Console fields
and record your settings.
4. Ensure you select the type of remote serial terminal you will be using and record your selection.
5. Select Save Changes and Exit and then shut down the ReadyBoard 910.
6. Connect the remote serial terminal (or the PC with communications software) to the COM port you
selected and recorded earlier in the BIOS Setup Utility.
7. Turn on the remote serial terminal or PC and set it to the settings you selected in the BIOS Setup Utility.
The default settings for the ReadyBoard 910 are:
 ANSI
 115200
 8 bits
 1 stop bit
 no parity
 no flow control
 VT-UTF8 Combo Key Support [Enabled]
 Recorder Modes [Disabled]
 Resolution 100x31 [Disabled]
 Legacy OS Redirection Resolution [80x24]
8. Restore power to the ReadyBoard 910 and press the F4 key after you see the following screen prompt.
Press to update BIOS