YSI ADV6600 - Manual (Page 40)

Section 3. Installation and Setup
ADV6600
Y S I
Environmental
Page 30
Amplitude The level of returned signal based on the concentration and/or particle
size found in the water.
Compass The heading, pitch, and roll data from the compass which is applied to
the raw velocity data to convert it to East, North, Up components.
Temperature The output of the temperature sensor associated with the ADV sensor.
The output is reported as “ADV Temperature”. Note that there is also a
temperature parameter associated with the Water Quality sensors which
will be similar, but probably not identical, to the “ADV Temperature”
due to differences in location and time constants.
Pressure The reading of the ADV6600 pressure sensor which can be translated
into depth of water value.
Battery Voltage The voltage associated with the internal C-cells of the ADV6600 or
external power source (whichever is greater).
Boundary Range The range from the tip of the ADV (transmitter) to the closest boundary
(i.e. the bottom of a stream) if within detectable range (varies depending
on angle and material type). The value is reported as a -1 if not detected
or is out of range.
Water Quality Data The water quality parameters which are active in the Report setup.
3-8. Exiting the ADV6600 Firmware
When you have finished setting up the ADV6600 firmware, be sure to close ADVantage 6600
completely by clicking the “x” in the upper right hand corner of the window. You will see the
following message:
Under virtually all circumstances, you will want to click the “Yes” selection so that the ADV6600
will power down to its idle mode in order to save power.
3-9. ADV6600 Firmware Upgrades