Winco DGC-2020 - Manual (Page 100)

5-2 DGC-2020 BESTlogic+ Programmable 9400200990 Rev B
BESTlogic+ Composition
There are three main groups of objects used for programming BESTlogic+. These groups are I/O,
Components, and Elements. For details on how these objects are used to program BESTlogic+, see the
paragraphs on Programming BESTlogic+.
I/O
This group contains Input Objects, Output Objects, Alarms, Pre-Alarms, and Senders. Table 5-1 lists the
names and descriptions of the objects in the I/O group.
Table 5-1. I/O Group, Names and Descriptions
Name Description Symbol
Input Objects
Logic 0 Sends out a Fixed 0 (Low).
Logic 1 Sends out a Fixed 1 (High).
Physical Inputs
IN1 - IN16
Connect to an input of another logic block.
Remote Inputs
Inx_RMx
Connect to an input of another logic block.
(Available only when a remote I/O module is
connected.)
Virtual Inputs
VIN1 - VIN4
Connect to an input of another logic block.
Status Input
Audible Horn
Connect to an input of another logic block.
Status Input
Auto Mode
Connect to an input of another logic block.
Status Input
Off Mode
Connect to an input of another logic block.
Status Input
Run Mode
Connect to an input of another logic block.
Status Input
Cool Down Timer Active
Connect to an input of another logic block.
Status Input
Emergency Stop
Connect to an input of another logic block.
Status Input
EPS Supplying Load
Connect to an input of another logic block.
Status Input
Pre Start Condition in Effect
Connect to an input of another logic block.
Status Input
Switch not in Auto
Connect to an input of another logic block.