Toa D-2000 Series Installation - Manual (Page 37)

37
4.5. Audio Monitor Line Connection When Multiple Units Are Connected
Connecting multiple D-2008SP units through monitor input and output terminals allows audio signals other
than that of the main unit to be monitored.
[Connection Example]
D-2008SP
(ID1)
Slot 8 Slot 1 3 4 5
Slot 8 Slot 1 5
Slot 8 Slot 1 7
Slot 3: D-2000DA1
Slot 4: D-2000DA1
Slot 5: D-2000AD1
Slot 5: D-2000AD1
Slot 8: D-2000DA1
Slot 7: D-2000AD1
D-2012C (ID 1)
Note:
D-2008SP
(ID 2)
D-2012C (ID 2)
D-2012C (ID 3)
D-2008SP
(ID 3)
Speaker
Power amplifier
Switching hub
Audio signals of the
D-2008SP units with
ID1 and ID2 only can
be monitored
Note: Audio signals of the
D-2008SP units with
ID1 and ID3 only can
be monitored.
Note: Audio signals of the
D-2008SP units with
ID1 through ID3 can
be monitored.
Monitor bus
Monitor bus
Monitor bus
Monitor output 1
Monitor input
Monitor input
Monitor input
Monitor input
Monitor output 1
Monitor output 2
Monitor output 2
Notes
• Set the identical ID number for the D-2008SP and D-2012C to be connected through monitor bus terminals.
Use the D-2000 Setting Software to set the ID number.
• Insert the audio module used for monitor input into one of Slots 5 – 8.
• Neither the D-936R Stereo input module nor D-937SP Digital input module can be used as a monitor input.
• When using the D-922F and D-922E Microphone/Line input module as monitor inputs, set the "PHANTOM"
switch to "OFF" and "Input sensitivity" to "+4 dB (LINE)."
• The headphones connected to the D-2008SP can only monitor audio signals from the channels of this D-
2008SP.