Toa D-2000 Series Installation - Manual (Page 36)

36
4.4. Connecting the Monitor Bus Terminal of the D-2008SP and D-2012C
When using the D-2012C's Line input terminal or headphone jack, connect the D-2012C's Monitor bus
terminal to the Monitor bus terminal on the D-2008SP.
Notes
• Set the identical ID number for the D-2008SP and D-2012C to be connected through monitor bus terminals.
Use the D-2000 Setting Software to set the ID number.
• If D-2008SP Console Setting is performed using the D-2000 Setting Software, the D-2008SP can be set to
receive audio signal from the D-2012C's line input terminal. If D-2012C Function Setting is set, the D-
2012C's monitor channel output can also be monitored with headphones.
Additionally, if the D-2008SP's output channel is set to "Monitor," output from the monitor channel selected
at the D-2012C can also be output to the D-2008SP's output channel.
D-2012C
D-2008SP
Monitor bus terminals
Category 5 or higher shielded
twisted pair cable for LAN
(with RJ45 connectors)