Toa D-2000 Series Installation - Manual (Page 14)

14
• E-Section
13
14
15
• F-Section
16
17
18
13. Line input signal level indicators
[SIGNAL, PEAK]
Display the signal level set with the Line input
volume control (15). The SIGNAL indicator lights
when a signal exceeding the reference level of
–20 dB is fed to the line input terminal. If a signal
at the line input terminals clips, the PEAK
indicator lights.
14. Line input terminals
Connect stereo equipment of stereo line level of
–10 dB* and 10 kΩ to these terminals. When
using these terminals, perform settings on the D-
2008SP side using the D-2000 Setting Software.
* 0 dB = 0.775 V
15. Line input volume control knob
Adjusts the signal input level from equipment
connected to the line input terminal. The volume
increases as the control knob is rotated
clockwise and decreases as it is rotated
counterclockwise. Adjust the level so that the
SIGNAL indicator lights without lighting the
PEAK indicator.
16. Monitor signal indicators [SIGNAL, PEAK]
Indicates the level of the signal being monitored.
The SIGNAL indicator lights when a signal being
monitored exceeding the reference level of –20
dB is fed to the line input terminal. If the signal
level approaches clipping volume, the PEAK
indicator lights. Select the channel to be
monitored using Monitor channel selector keys
(8).
17. Monitor volume control knob
Adjusts the volume of sound monitored by the
headphones connected to the Headphone jack.
The volume increases as the control knob is
rotated clockwise and decreases as it is rotated
counterclockwise.
18. Headphone jack
Applicable impedance is 16 Ω or greater. This
jack allows monitoring of the sound output from
the channel selected with the Monitor channel
selector keys (8). Plug in headphones of 16 Ω or
more to this jack. Adjust the monitor volume with
the Monitor volume control knob (17).