TeeJet Legacy 6000 RMS_EXT User Guide - Manual (Page 74)

5-10 Chapter 5 - RMS Mapper
Start Mapping
RMS Mapper for the Legacy 6000
Software Version 2.00
Start Mapping
When the Mapper Application Setup process is complete, real-time mapping can begin by press-
ing the Mapper soft-key, located on the Mapper Launcher page (Figure 5-7).
The Map Page
The first real-time page is the Map page. You can perform all mapping tasks in this page. The right
side soft-keys in the Map page represent all of the available mapping functions, such as map
objects, zoom, and options. Table 5-6 describes each of these soft-keys in more detail.
The left column of soft-keys represent the pre-defined point or hazard objects. These soft-keys are
setup in the Mapper setup menu (See “Road Markers Setup” on page 5-9). Typically, commonly
used point and hazard objects have their own soft-key for rapid use.
When the Mapper soft-key is pressed, the RMS-EXT software loads all setup information. This
loading process may take a few seconds to complete. The Map page is the first real-time page
seen.
Figure 5-7: The Mapper Launcher Page
Start Mapper
soft-key