TeeJet Legacy 6000 RMS_EXT User Guide - Manual (Page 23)

RMS-EXT for the Legacy 6000
Software Version 2.00
Chapter 2 - Getting Started 2-11
System Setup
Vehicle Setup
Vehicle Setup allows you to select the spray configuration profile from an imported list.
To access Vehicle Setup from the Main Launcher page (Figure 2-2), select System Setup (Figure
2-7) / Vehicle Setup(Figure 2-10)
Figure 2-10: The Vehicle Setup Page
Setting Description
Spray Config The name of the Spray Configuration profile that was created in RMS Office and
imported into the Legacy 6000. The Spray Config page, (Figure 2-11), shows a repre-
sentation of the current spray configuration. Review the RMS Office user guide for more
information on importing user profiles.
Vehicle Allows the selection of the vehicle profile. This profile contains the vehicle ID, rate con-
troller type, and carrier units. This profile is created in RMS Office and imported into the
Legacy 6000. Review the RMS Office user guide for more information on importing user
profiles.
Com Port Defines the com port that the GPS receiver is connected to.
Table 2-4: The Vehicle Setup Settings