TeeJet Legacy 6000 RMS_EXT User Guide - Manual (Page 22)

2-10 Chapter 2 - Getting Started
System Setup
RMS-EXT for the Legacy 6000
Software Version 2.00
GPS Receiver Setup
GPS Receiver setup defines the DGPS accuracy and how the GPS receiver communicates with
the Legacy 6000 console. Table 2-3 lists the GPS Receiver setup parameters.
To access GPS Setup from the Main Launcher page (Figure 2-2), select System Setup (Figure 2-
7) / GPS Receiver Setup (Figure 2-9).
To change any of the GPS Receiver settings, highlight the setting name listed in the center column
of the GPS Receiver Setup page and press Enter. Use the Setup Wizard to walk through and
make any necessary changes to the settings. When done making changes, press the Forward
Arrow to save and exit GPS Receiver Setup. Press the Back Arrow to exit without saving any
changes.
Figure 2-9: The GPS Receiver Setup Menu Page
Setting Description
Accuracy Defines the accuracy of the DGPS receiver. Choices are RTK and Sub-meter.
Height Defines the height of the antenna above the ground.
Com Port Defines the com port that the GPS receiver is connected to.
Baud Rate Defines the selected com port baud rate.
Data Bits Defines the selected com port data bit setting.
Stop Bits Defines the selected com port stop bit setting.
Parity Defines the selected com port parity.
Table 2-3: The GPS Receiver Setup Settings