TeeJet RMS Office - Manual (Page 35)

RMS Office
Software Version 3.10
Chapter 2 - RMS Profiles 2-17
The Chemical Mixture Profile
Calculating the Mixture
Now that you have entered the two chemicals, the chemical application rates, and the total mix
volume, the next step is to calculate the mixture. To calculate the mixture, press the Calculate but-
ton located at the lower left corner of the Chemical Calculator dialog. The Chemical Calculator cal-
culates the following values:
• Mid-Tech Console Rate.
• Quantity of required material for chemical 1.
• Quantity of required material for chemical 2.
• Quantity of required carrier.
• Application rate of the carrier (calculated from the Maximum Mix Ratio entered for the Dry
material in Chemical Profile).
• Area that this mixture can cover based on chemical application rates.
See Figure 2-15 for the calculated results of this example. When satisfied with the calculation,
press the OK button to return to the Chemical Mixture Main menu page (see Figure 2-16). Notice
that, on the Main page, all of the appropriate menu fields have been automatically filled in, includ-
ing the mixture name.
If you know the average boom width and average speed of the vehicle during the application pro-
cess, enter these values into the Chemical Calculator and calculate the total distance you can
cover as well as the Average Pump Flow Rate.
Figure 2-14: Total Mix Volume Entered