Interlogix NVR 21 (S/P) User Manual - Manual (Page 44)

Chapter 5: Live view
38 TruVision NVR 21(S/P) User Manual
To set the camera sequencing:
1. From the menu toolbar, click Display Mode Settings > Layout > View .
2. From Video Output Interface , select the desired monitor from the drop-down list.
3. From the multiview layout selection bar, select the desired multiview layout.
4. Select the video tile of the camera whose order you want to change. The selected
tile is highlighted green.
5. In the selected tile, select the new camera sequence order by scrolling through the
list of available camera numbers.
Note: “X” means that the camera is not displayed.
6. Click Apply to save the settings.
7. Click Back to return to live view.
General settings
Use this screen to configure the monitor image, GUI language, login password
requirement, monitor resolution as well as to configure the recorder name and address.
See Figure 17 below.
The recorder can support NTSC or PAL video output. The video format is auto
detected.
The changes are immediately implemented once Apply is clicked to save the settings.
Figure 17: Monitor setup screen: General Settings
Table 12: Description of the Monitor setup screen: General Settings
Option Description
Language Change the language of the system.
Select the desired language from the drop-down list and click Apply . The
language displayed changes immediately.