Interlogix NVR 21 (S/P) User Manual - Manual (Page 104)

Chapter 11: Alarm settings
98 TruVision NVR 21(S/P) User Manual
Motion detection set up
To set up motion detection:
1. From the menu toolbar, click Camera Management > Motion .
2. Select the IP camera to detect motion. Each camera must be set up individually.
3. Check Enable Motion Detection .
4. Select the areas sensitive to motion.
Click and drag the mouse cursor across the screen. The area selected appears as a
red grid. Areas covered by the red grid are sensitive to motion detection.
Click Full screen to activate the whole screen or Clear to clear the screen.
Note: The motion grid is sensitive to motion during configuration.
5. Set the sensitivity level.
Drag the Sensitivity scroll bar to the desired sensitivity level. The highest value is on
the right of the bar.
6. Select the cameras that will record the motion detected.
Click Rule . The Rule screen appears. Click the Trigger Channel tab and select the
cameras that will record when a motion alarm is triggered. Click Apply to save the
settings.