Interlogix NVR 21 (S/P) User Manual - Manual (Page 40)

Chapter 5: Live view
34 TruVision NVR 21(S/P) User Manual
Sequencing live view mode using the front panel:
1. Select the camera where you want to start sequencing.
2. Press the Seq button on the front panel to start sequencing.
3. Press the Seq button again to stop the sequencing.
Sequencing live view mode using the mouse:
1. Select the camera where you want to start sequencing.
2. Right-click the mouse and select Start auto-switch to start the sequencing.
3. Right-click the mouse and select Stop auto-switch to stop the sequencing.
Accessing frequently used commands
The quick access toolbar in live view lets you quickly access regularly used commands.
Position the cursor over a video image and left-click the mouse. The toolbar appears
(see Figure 13 below).
Figure 13: Quick access toolbar
Table 10: Description of the quick access toolbar icons
Icon Description
Freeze: Freeze the live image of the selected camera. Although the image pauses, time
and date information does not. The system clock continues to run.
Manual recording: Start/stop manual recording.
The icon is red when manual recording is enabled. See “Manual recording” on page 88
for information on setting up this function.
Instant playback: Playback the recorded video from the last five minutes (default time).
If no recording is found, then there was no recording made.
Click the icon and select the desired camera. Click OK.
See “Instant playback” on page 54 for information on programming this time.
Audio: Enable/Disable audio output. The audio option must already have been setup in
the Display menu.
Quick snapshot: Capture a snapshot of a video image. The image is saved on the unit.
PTZ control: Enter PTZ control mode.
Digital zoom: Enter digital zoom. See “Digital zoom” below for further information.