Network – IC Realtime Flex Series: 32-CH High Performance H.264E 2U DVR User Manual

Page 72

System default setup is:
 Function: Console
 Baud rate:115200
 Data bit:8
 Stop bit:1
 Parity: None

After completing all the setups please click save button, system goes back to the previous menu .

Figure 5-8

5.3.5 Network

Here is for you to input network information. See Figure 5-9.
 MAC address: The host in the LAN can get a unique MAC address. It is for you to access in the

LAN. It is read-only.

 IP address: Here you can use up/down button (



) or input the corresponding number to

input IP address. Then you can set the corresponding subnet mask the default gateway.

 Subnet prefix: The input value ranges from 0 to 128. It is to mark a specified network MAC

address. Usually it includes an organization of multiple-level.

 Default gateway: Here you can input the default gateway. Please note system needs to

check the validity of all IPv6 addresses. The IP address and the default gateway shall

be in the same IP section. That is to say, the specified length of the subnet prefix shall

have the same string.

 DHCP: It is to auto search IP. When enable DHCP function, you can not modify IP/Subnet

mask /Gateway. These values are from DHCP function. If you have not enabled DHCP

function, IP/ Subnet mask/Gateway display as zero. You need to disable DHCP function to

view current IP infor mation. Besides, when PPPoE is operating , you can not modify

IP/Subnet mask /Gateway.

 TCP port: Default value is 37777. You can change if necessary.
 UDP port: Default value is 37778. You can change if necessary.