IC Realtime Flex Series: 32-CH High Performance H.264E 2U DVR - Manual (Page 143)

133
Parameter Function
Tour  Display the selected video in local monitor window.
 Tour interval and tour mode are set in DVR local menu (chapter
5.3.9 Display )
PTZ
Activation  Here you can set PTZ movement when alarm occurs. Such as go to
preset x when there is an alarm.
Capture You need to input capture channel number so that system can backup
motion detection snapshot file.
Matrix
Enable Please note this function is valid in motion detect mode.
Check the box here to enable video matrix function. Right now system
supports one-channel tour function. System takes
“first come and first
serve ” principle to deal with the activated tour. System will process the
new tour when a new alarm occurs after previous alarm ended.
Otherwise it restores the previous output status before the alarm
activation.
Copy It is a shortcut menu button. You can copy current channel setup to
one or more (all) channels.
Save You can click save button after you complete setup for one channel,
or you can complete the whole setups and then click save button.
Refresh Click this button to get device latest configuration information.
7.5.2.8 PTZ
PTZ interface is shown as in Figure 7-50.
Please note, before operation please make sure you have set speed dome address. And DVR
and speed dome connection is OK.
Figure 7-50
Please refer to the following sheet for detailed information.
Parameter Function
Channel
You can select monitor channel from the dropdown list. .