IC Realtime Flex Series: 32-CH High Performance H.264E 2U DVR - Manual (Page 55)

45
Figure 4-26
4.7 Alarm Setup and Alarm Activation
Before operation, please make sure you have proper ly connected alar m devices such as
buzzer.
4.7.1 Go to alarm setup interface
In the main menu, from Setting to A lar m, you can see alar m setup interface. See Figure 4-27.
4.7.2 Alarm setup
Alar m interface is shown as below. See Figure 4-27.
 Alarm in: Here is for you to select channel number.
 Event type: There are two types. One is local input and the other is network input.
 Type: normal open or normal close.
 PTZ activation: When an alarm occurred, system can activate the PTZ operation. The PTZ
activation lasts an anti-dither period.
 In the Pan/Tilt/Zoom interface (Main menu->Setting-> Pan/Tilt/Zoom), please set video
channel, speed dome protocol and etc.
 Select the channel of current speed dome as current monitor video and the right click
mouse to select Pan/Tilt/Zoom item. Now you can set preset, tour pattern.
 In Figure 4-27, click “select” button, you can see an interface is shown as in Figure 4-28.
Here you can set the activation operation such as preset tour, pattern and enable.
 Period: Click set button, you can see an interface is shown as in Figure 4-29. Here you can
set for business day and non-business day. In Figure 4-29, click set button, you can see an
interface is shown as in Figure 4-30. Here you can set your own setup for business day and
non-business day.
 Anti-dither: Here you can set anti-dither time. The value ranges from 5 to 600s. The anti-
dither time refers to the alar m signal lasts time. It can be seem as the alar m signal activation
stays such as the buzzer, tour, PT Z activation, snapshot, channel record. The stay time