Futaba 14SG 2.4GHz - Manual (Page 84)

83
ŏ 6HOHFW WKH IXQFWLRQ QDPH
DQG UHWXUQ WR WKH /LQNDJH
PHQX E\ WRXFKLQJ WKH
R T N E X W W R Q
2 U W K H
H O M E / E X I T E X W W R Q L V
SXVKHG
THR CUT 6WRSV WKH HQJLQH VDIHO\ DQG HDVLO\DLUSODQH DQG KHOLFRSWHU RQO\
Throttle cut provides an easy way to stop the
engine. Generally speaking, modelers will do so
E\ ÀLSSLQJ D VZLWFK ZLWK WKH WKURWWOH VWLFN DW LGOH
The action is not functional at high throttle to
avoid accidental dead stick landings. The switch’s
location and direction must be chosen, as it defaults
to NULL.
Individually adjust the Throttle Cut activation
setting for each condition. (helicopter)
Throttle cut setting procedure
$FWLYDWH WKH IXQFWLRQ
0RYH WKH FXUVRU WR WKH >$&7@ LWHP DQG WRXFK
WKH 571 EXWWRQ WR VZLWFK WR WKH GDWD LQSXW
PRGH
6HOHFW WKH $&7 PRGH E\ VFUROOLQJ WKH WRXFK
VHQVRU
*The display blinks.
7 R X F K W K H 5 7 1 E X W W R Q W R D F W L Y D W H W K H
IXQFWLRQ DQG UHWXUQ WR WKH FXUVRU PRGH
6ZLWFK VHOHFWLRQ
0RYH WKH FXUVRU WR WKH >6:@ LWHP DQG DFFHVV
WKH VZLWFK VHWXS VFUHHQ E\ WRXFKLQJ WKH
571 EXWWRQ DQG VHOHFW WKH VZLWFK DQG 21
GLUHFWLRQ
*For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.
7KURWWOH FXW SRVLWLRQ VHWWLQJ
0RYH WKH FXUVRU WR WKH >326@ LWHP DQG WRXFK
WKH 571 EXWWRQ WR VZLWFK WR WKH GDWD LQSXW
PRGH
$GMXVW WKH VHUYR RSHUDWLRQ SRVLWLRQ DW WKURWWOH
FXW RSHUDWLRQ E\ VFUROOLQJ WKH WRXFK VHQVRU
,QLWLDO YDOXH
$GMXVWPHQW UDQJH a
*When the RTN button is touched for one second, the servo
operation position is reset to the initial value.)
7RXFK WKH 571 EXWWRQ WR HQG WKH DGMXVWPHQW
DQG UHWXUQ WR WKH FXUVRU PRGH
*With the selected cut switch ON and the throttle stick at idle;
adjust the rate until the engine consistently cuts off.
However, be sure that the throttle linkage is not pulled too
tight or unreasonable force is not applied to the servo.
Designating a Throttle Cut setting position.
(helicopter)
*A throttle cut function acts in the low side of the throttle
position.
*"THRO" setting is common with all condition.
:DUQLQJ
Normal setting is slightly above idle.
7R DGG WKH 7KURWWOH &XW SRVLWLRQ XVH WKH
FXUVRU WR VHOHFW WKH 7+52 SHUFHQWDJH
GHVLUHG WKHQ SUHVV DQG KROG WKH 571 EXWWRQ
IRU RQH VHFRQG
*Since conditions are not offered when an Airplane is selected,
the Throttle Cut options will vary from the options noted
below.
*The Throttle Cut POS and SW settings are utilized for all
conditions.
*If the Throttle Cut switch is activated, or on, this status will
continue even if the condition is changed to an inhibited
setting.
*If the condition is inhibited (INH) the Throttle Cut is off if
the SW is in the off position and the throttle stick is low.
ŏ 6HOHFW >7+5 &87@ LQ WKH /LQNDJH PHQX DQG DFFHVV
WKH VHWXS VFUHHQ VKRZQ EHORZ E\ WRXFKLQJ WKH
571 EXWWRQ
ŏ &XUUHQW WKURWWOH SRVLWLRQ
ŏ ,QGLYLGXDOO\ DGMXVW WKH 7KURWWOH &XW DFWLYDWLRQ
VHWWLQJ IRU HDFK FRQGLWLRQ KHOLFRSWHU
ŏ &XW SRVLWLRQ
6FUROOLQJ
ŏ 0RYLQJ FXUVRU
ŏ 6HOHFWLQJ PRGH
ŏ $GMXVWLQJ YDOXH
ŏ 7KURWWOH
FXW VWDWXV
ŏ 7KURWWOH
FXW VWDWXV
ŏ 7KURWWOH
VWLFN SRVLWLRQ