Futaba 14SG 2.4GHz - Manual (Page 165)

164
ŏ 6HOHFW WKH IXQFWLRQ QDPH
DQG UHWXUQ WR WKH KRPH
VFUHHQ E\ WRXFKLQJ WKH
RTN EXWWRQ
2U D HOME/
EXIT EXWWRQ LV SXVKHG
TIMER ST1/ST2 7LPHU VHWWLQJ
The Timer function may be set for any desired
time, i.e. engine run time, specified times for
competitions, etc. Two independent timers are
provided for your use. The timers are stored
independently with each model, meaning that
when you switch between model setups, the timer
associated with the new model is brought up
automatically.
The timers may be set to start and stop from the
motion of any switch or stick. You may set the ON and
OFF directions freely. Each timer has a capacity of up
to 59 minutes 59 seconds.
Each timer may be set for count-down (DOWN
mode) or count up (UP mode) operation with a
target time or for count up to 99 hours 59 minutes
(HOUR mode).
If a target time is set and the timer reaches the set
time, a buzzer sound for each count is generated.
Countdown timers sound one short beep during
the last twenty seconds and two short beeps during
the last ten seconds before reaching the target, then
a long tone at the target time, and continue counting
with displaying a minus (-) sign. Count-up timers
also beep the last twenty and ten seconds, beep the
target time, and keep counting upwards until shut
down.
A mode which sounds an alarm each minute of
the time remaining up to the timer alarm time can
be selected.
The HOUR mode is convenient when used in
engine maintenance period and other long-term
measurements.
* When the HOUR mode is set, "xx (hour): xx (minute)"
is displayed on the count time display. Seconds are not
displayed.
* When the HOUR mode is set, ":" blinks each second during
timer operation.
* When the HOUR mode is set, the alarm function is
inhibited.
ŏ 6HOHFW 67 RU 67 DW WKH KRPH VFUHHQ DQG
FDOO WKH VHWXS VFUHHQ VKRZQ EHORZ E\
WRXFKLQJ WKH 571 EXWWRQ
6FUROOLQJ
ŏ 0RYLQJ FXUVRU
ŏ 6HOHFWLQJ PRGH
ŏ $GMXVWLQJ YDOXH