Futaba 14SG 2.4GHz - Manual (Page 30)

29
S.BUS Wiring example
%DWWHU\
%DWWHU\
*<
([WHQVLRQ
FRUG
6ZLWFK
6ZLWFK
7HUPLQDOER[
+8%
+8% +8%
+8% +8%
+8%
+8%
ق$QRWKHUSRZHUVXSSO\ك
+8%
6%866HUYR
6%866HUYR
Since the channel number is memorized by
the S.BUS itself, any connector can be used.
When the SBD-1 (sold separately) is used,
ordinary servos can be used with the
S.BUS system.
When a large number of servos are used or
when high current servos are used, the servos
can be driven by a separate power supply by
using a separate Power Supply 3-way Hub.
7HUPLQDOER[
Four connectors can be inserted
Three connectors can be
inserted.
Used when using a separate
power supply battery.
6%86
3RUW
6%
*When using 8/SB as S.BUS, you must set the receiver to
Mode B or Mode D. See R7008SB CH MODE TABLE.
Warning
Power supply
Please make sure that you
use a battery that can deliver
e n o u g h c a p a c i t y f o r t h e
number and kind of servos
u s e d . A l k a l i n e b a t t e r i e s
cannot be used.