Futaba 14SG 2.4GHz - Manual (Page 38)

37
Link procedure (T14SG/R7008SB)
(DFK WUDQVPLWWHU KDV DQ LQGLYLGXDOO\ DVVLJQHG XQLTXH ,' FRGH ,Q RUGHU WR VWDUW RSHUDWLRQ WKH UHFHLYHU
PXVW EH OLQNHG ZLWK WKH ,' FRGH RI WKH WUDQVPLWWHU ZLWK ZKLFK LW LV EHLQJ SDLUHG 2QFH WKH OLQN LV PDGH
the ID code is stored in the receiver and no further linking is necessary unless the receiver is to be used
with another transmitter. When you purchase additional R7008SB receivers, this procedure is necessary;
otherwise the receiver will not work.
Link procedure
3ODFH WKH WUDQVPLWWHU DQG WKH UHFHLYHU FORVH
to each other within half (0.5m) meter.
2. Turn on the transmitter.
3. Select [SYSTEM] at the Linkage menu and
access the setup screen shown below by
touching the RTN button.
4. When you use two receivers on one model,
you must change from [SINGLE] to [DUAL].
* O n l y t w o r e c e i v e r s c a n b e u s e d . I n
"DUAL", two setting items come out. Input,
respectively.
) ZLOO EH FKRVHQ LI LW LV XVHG LQ )UDQFH RWKHUV
"G" general.
6. When changing battery fail-safe voltage
f r o m t h e i n i t i a l v a l u e 3 . 8 V , v o l t a g e i s
changed here.
2QO\ LQ )$667HVW 0RGH
7.[LINK] is chosen by scrolling and the RTN
button is pushed. The transmitter will emit a
chime as it starts the linking process.
8. When the transmitter starts to chime, power
on the receiver. The receiver should link to
the transmitter within about 1 second.
9. If linking fails, an error message is displayed.
Bring the transmitter closer to the receiver
and repeat the procedure above from Step 2.
10. ACT will be chosen if telemetry is used.
It is INH when not using it.
:You can do this through the LINKAGE Menu
and scroll to System and press RTN.
d this th h th LINK
,' RI D 3ULPDU\
receiver displays.
In DUAL, a primary receiver
i s l i n k p r e v i o u s l y . N e x t , a
secondary receiver is link.
ID of a Secondary
receiver displays.