Futaba 14SG 2.4GHz - Manual (Page 127)

126
ƔSRLQW FXUYH VHWWLQJ DLUSODQH
>&XUYH UDWH VHWWLQJ@
1. Move the cursor to the curve rate setting
LWHP OHIW VLGH \RX ZDQW WR DGMXVW DQG WRXFK
the RTN button to switch to the data input
mode.
$GMXVW WKH UDWH E\ VFUROOLQJ WKH WRXFK VHQVRU
$GMXVWPHQW UDQJH a
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
7RXFK WKH 571 EXWWRQ WR HQG WKH DGMXVWPHQW
and return to the cursor mode.
2. Repeat this procedure for each point.
>0RYLQJ FXUYH SRLQW@
1. Move the cursor to the curve point setting
LWHP \RX ZDQW WR DGMXVW DQG WRXFK WKH 571
button to switch to the data input mode.
$GMXVW WKH FXUYH SRLQW E\ VFUROOLQJ WKH WRXFK
sensor.
$GMXVWPHQW UDQJH 8S WR LQ IURQW RI WKH
DGMRLQLQJ SRLQW
*When the RTN button is touched for one second, the curve
position is reset to the initial value.)
7RXFK WKH 571 EXWWRQ WR HQG WKH DGMXVWPHQW
and return to the cursor mode.
2. Repeat this procedure for each point.
>'HOHWLQJUHWXUQLQJ FXUYH SRLQW@
Move the cursor to the curve point setting
LWHP \RX ZDQW WR GHOHWHUHWXUQ DQG WRXFK
the RTN button for one second.