Futaba 14SG 2.4GHz - Manual (Page 140)

139
ŏ 6HOHFW WKH IXQFWLRQ QDPH
and return to the Model
menu by touching the
R T N b u t t o n .
O r t h e
H O M E / E X I T b u t t o n i s
pushed.
V-TAIL >&RUUHVSRQGLQJ PRGHO W\SH@ $LUSODQHJOLGHU 9WDLO
This function enables adjustments for left and
right rudder angle changes during elevator and
rudder operation of a V-tail airplane.
V-tail is when two servos are used together to
control rudder movement as elevators. In addition
to each elevator side moving up and down together,
each side moves in opposite directions when moving
as rudders. On a V-tail, this is also known as a
Ruddervator, as they serve the same purpose.
5XGGHU IXQFWLRQ
L e f t a n d r i g h t t r a v e l
D G M X V W P H Q W R I U X G G H U
operation
(OHYDWRU IXQFWLRQ
8S DQG GRZQ WUDYHO DGMXVWPHQW RI
elevator operation
ŏ 6HOHFW >97$,/@ DW WKH 0RGHO PHQX DQG
access the setup screen shown below
by touching the RTN button.
Scrolling
ŏ 0RYLQJ FXUVRU
ŏ 6HOHFWLQJ PRGH
ŏ $GMXVWLQJ YDOXH
ŏ 7R QH[W SDJH
Setting method
Ɣ 7UDYHO DGMXVWPHQW
Move the cursor to the item you want to
DGMXVW DQG WRXFK WKH 571 EXWWRQ WR VZLWFK WR
the data input mode.
$GMXVW WKH UDWH E\ VFUROOLQJ WKH WRXFK VHQVRU
,QLWLDO YDOXH
$GMXVWPHQW UDQJH a
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
Touch the RTN button to return to the cursor
mode.
*If the mixing direction is reversed, adjustments can be made
by changing the mixing rate polarity (+ or -).
*If a large value of travel is specified, when the sticks are
moved at the same time, the controls may bind or run out of
travel. Decrease the travel until no binding occurs.