Futaba 14SG 2.4GHz - Manual (Page 138)

137
ŏ 6HOHFW WKH IXQFWLRQ QDPH
and return to the Model
menu by touching the
R T N b u t t o n .
O r t h e
H O M E / E X I T b u t t o n i s
pushed.
GYRO >&RUUHVSRQGLQJ PRGHO W\SH@ $LUSODQHJOLGHU JHQHUDO
This function is used when a GYA Series gyro
is used to stabilize the aircraft's attitude. The
sensitivity and operation mode (Normal mode/
AVCS mode) can be changed via a switch.
ŏ 7KUHH UDWHV 5DWH 5DWH 5DWH FDQ EH
switched.
ŏ 8S WR D[HV *\UR*\UR *\UR FDQ EH
simultaneously controlled.
Note: This setting does not assign a sensitivity
channel. To do so, use the Linkage menu
prior to assigning the sensitivity channel
(Gyro/Gyro2/Gyro3), be sure to select an
unused channel.
Set the [Control] and [Trim] settings other than
Function to [--].
ŏ 7KH RSHUDWLRQ PRGH $9&6125
and sensitivity of the three axis
*\UR*\UR*\UR FDQ EH VHW
ŏ 6HOHFW >*<52@ DW WKH 0RGHO PHQX DQG
access the setup screen shown below
by touching the RTN button.
Scrolling
ŏ 0RYLQJ FXUVRU
ŏ 6HOHFWLQJ PRGH
ŏ $GMXVWLQJ YDOXH
ŏ 7R QH[W SDJH
(Active rate # display)
ŏ * \ U R W \ S H
selection
ŏ $&7,1+
ŏ 6ZLWFK VHOHFWLRQ
ŏ 5 D W H V H W X S
screen selection
>5DWH VHWXS VFUHHQ@
>5DWH VHWXS VFUHHQ@
>5DWH VHWXS VFUHHQ@
Setting method
*Prior to using the Function menu in the Linkage menu to
assign the sensitivity channel (Gyro/Gyro2/Gyro3) select an
unused channel.
Set [Control] and [Trim] other than function to [--].
Ɣ5DWH VHWXS VFUHHQ VHOHFWLRQ
Move the cursor to the setup screen selection
item and touch the RTN button to switch
to the data input mode. Select the setup
screen # by scrolling the touch sensor.
Touch the RTN button to change the setup
screen and return to the cursor mode.
Ɣ$FWLYDWH WKH IXQFWLRQ
0RYH WKH FXUVRU WR WKH >,1+@ LWHP DQG WRXFK
the RTN button to switch to the data input
PRGH 6HOHFW WKH $&7 PRGH E\ VFUROOLQJ WKH
touch sensor.
*The display blinks.
T o u c h t h e R T N b u t t o n t o a c t i v a t e t h e
function and return to the cursor mode.