Futaba 14SG 2.4GHz - Manual (Page 34)

33
BASIC OPERATION
How to charge the NiMH battery HT5F1800B
for the transmitter
Danger
The NiMH battery HT5F1800B is only for
your T14SG. Do not use this battery for other
equipment.
Be sure to use the attached special charger to
charge the battery.
*If you take the NiMH battery HT5F1800B out of the
transmitter, you can use the optional quick charger CR-2000
corresponding to NiMH battery.
[Method of charging battery]
*Connect to AC outlet
specified.
ƔSpecial charger
Receiver Batt.
Charging display
To T14SG charge
connector
Transmitter Batt.
Charging display
1. Connect the special charger to the wall
socket (AC outlet).
2. Connect the connectors to the T14SG
charging jack.
&RQ¿UP WKDW WKH FKDUJLQJ LQGLFDWRU /(' ODPS LV RQ
*Turn off the transmitter while charging the battery.
3. Remove the battery after 15 hours.
*Battery charging will not automatically stop. Remove the
battery and transmitter from the charger and remove the
charger from the wall socket.
*It is recommended to reactivate the battery by cycling
several times if the battery has not been used for a long
period.
*In the case of NiMH/NiCd batteries, you may find poor
performance of the battery if you have used the battery
only for a short period or if you repeat charging while the
battery is not fully discharged. It is suggested to discharge
the battery to the recommended level after use. It is also
recommended to charge the battery just before use.
Battery Charging
Before charging batteries, read the "Cautions for handling battery and battery charger" in the section
"NiMH/NiCd Battery Safety and Handling Instructions".