beautypg.com

Futaba 14SG 2.4GHz User Manual

Page 46

background image

45

throttle stick in the 1/3 or less (slow side) position.

5. Idle down setting (Airplane)

The idling speed can be lowered with one touch

by a switch without changing the throttle trim
position. Perform this setting with the Idle Down
function of the Linkage Menu. After activating the
Idle Down function and selecting the switch, adjust
the idle down speed. For safety, the idle down
function acts only when the throttle stick is in the
lowest part of its throw.

*While the Throttle Cut function is in operation, the Idle

Down function does not work.

6. D/R function

D/R function is used to adjust the throw and

operation curve of the stick functions (aileron,
elevator, rudder and throttle) for each switch
SRVLWLRQ DLUSODQH RU HDFK ÀLJKW FRQGLWLRQ JOLGHU
7KLV LV QRUPDOO\ XVHG DIWHU WKH PRGHOHU KDV GH¿QHG
the maximum throw directions in the End Point
settings.

(Airplane)

(Glider)

7. Airbrake (Airplane)

This function is used when an airbrake is

necessary when taking off or diving, etc. Please
note: this menu item is only available under certain
ZLQJ FRQ¿JXUDWLRQV )RU H[DPSOH LW ZLOO QRW DSSHDU
if a single aileron wing type has been selected.

7KH SUHVHW HOHYDWRU DQG ÀDS RIIVHW DPRXQW FDQ

be activated by a switch.

The offset amount of the aileron, elevator, and

flap servos can be adjusted as needed. Also the
VSHHG RI WKH DLOHURQ HOHYDWRU DQG ÀDS VHUYRV FDQ
be adjusted. You can also set the Auto Mode, which
will link Airbrake to a stick, switch, or dial. A
separate stick switch or dial can also be set as the
ON/OFF switch.

$GGLWLRQ RI ÀLJKW FRQGLWLRQV *OLGHU

The Condition Select function automatically

allocates the normal condition (NORMAL) for
each model. NORMAL is the default condition and
is the only one active when a new model type is
GH¿QHG

,I \RX ZDQW WR DGG ÀLJKW FRQGLWLRQV SOHDVH UHIHU

to a description of the CONDITION function.

*The NORMAL is always on, and remains on until other

conditions are activated by switches, stick positions, etc.
Please refer to the section entitled Switch Selection Method
for additional information on how to do so.

*It is possible to customize the activation of the flight

conditions.

*The Condition Delay can be programmed for each channel.

The Condition Delay is used to change the servo throw
smoothly when switching conditions.