beautypg.com

5 setting the configuration parameters – EVCO EVF328J9 User Manual

Page 34

background image

EVCO S.p.A.

EVF 300 series | Installer manual ver. 1.1 | Code 144F300E114

Page 34 of 62

Operate as follows to set the power distributed at the floor:

6.

Ensure that the device is switched on and that no

other procedure is in progress.

7.

Press and release the "FLOOR" key twice: the

LED of the “LOWER” display will flash and the top

part of the display will show the flashing power

value.

8.

Press and release the "UP" or "DOWN" key within

15 s to set the power value, see also parameters

c0 and c1.

9.

Press and release the "FLOOR" key or do not

operate for 15 s: the

LED will switch off and

then the device will exit the procedure.

Operate as follows to exit the procedure before the operation

is complete:

10.

Do not operate for 15 sec (any changes will be

saved).


14.5

Setting the configuration

parameters

Operate as follows to access the procedure:

1.

Make sure there is no cooking cycle or any

procedure in progress.

2.

Hold the UP and DOWN key for 4 s: the top part of

the “UPPER” display will show“PA”.

3.

Press and release the “TOP” key or the “FLOOR”

key: the “LOWER” part of the display will show

0”.

4.

Press and release the “DOWN” key within 15 s to

set “-19”.

5.

Press and release the “TOP” key or the “FLOOR”

key or do not operate for 15 s.

6.

Hold the "UP" and "DOWN" key for 4 s:

-

in the event of operation with an

analogue input, the top part of the

“UPPER” display will show “SP

-

in the event of operation with two

analogue inputs, the top part of the

“UPPER” display will show “SP1

Operate as follows to select a parameter:

7.

Press and release the “UP” key or the “DOWN”

key.

Setting the power distributed at the floor

Setting the configuration parameters

This manual is related to the following products: