EVCO EVF328J9 - Manual (Page 23)

EVCO S.p.A. EVF 300 series | Installer manual ver. 1.1 | Code 144F300E114
Page 23 of 62
8 "COOKING TIMER" FUNCTION
8.1 Preliminary notes
The "cooking timer" function allows to start the residual count
of a time.
Start-up of the cooking timer count causes the start-up of the
cooking cycle; the interruption of the cooking timer count
causes the interruption of the cooking cycle.
The count is displayed in the bottom part of the “UPPER”
display; during the count, the “TIMER” LED is on.
The vent is activated for the time established with parameter
c6 with the advance defined with parameter c5 on conclusion
of the cooking timer count.
On conclusion of the cooking timer count, the buzzer is
activated for the time established with parameter c4 and the
lower part of the “UPPER” display shows flashing “End”.
If the power supply should be cut-off during the cooking timer
count and the duration of the cut-off is less than the time
established with parameter r13, on restoring the power
supply, the cooking timer count will be re-proposed (if vice
versa, the duration of the cut-off is longer than the time
established with parameter r13, on restoring the power
supply, the cooking timer count will be interrupted).
Finally, using parameters t8 and t9 it is possible to enable a
restriction between steam injection and the cooking timer
count.
8.2 Setting the cooking timer
The cooking timer is displayed in the hours:minutes format.
Operate as follows to set the hours:
1. Ensure that the device is switched on and that no
other procedure is in progress.
2. Press and release the "CLOCK" key: the “TIMER”
LED will switch on and the bottom part of the
“UPPER” display will show the cooking timer count;
the hours value will flash.
3. Press and release the UP or DOWN key within 15 s
to set the value of the hours.
Operate as follows to set the minutes:
4. Press and release the “CLOCK” key while setting
the hours:minutes value will flash.
5. Press and release the UP or DOWN key within 15 s
to set the value of the minutes.
Operate as follows to exit the procedure:
6. Press and release the “CLOCK” key while setting
the minutes: the “TIMER” LED will switch off and
then the device will exit the procedure.
Setting the cooking timer