EVCO EVF328J9 User Manual
Page 28

EVCO S.p.A.
EVF 300 series | Installer manual ver. 1.1 | Code 144F300E114
Page 28 of 62
Operate as follows to set the switch-on time:
6.
To set the hours, press and release the
“PROGRAMS” key while setting the program to be
started: the hours value will flash.
7.
Press and release the UP or DOWN key within 15 s
to set the value of the hours.
8.
To set the minutes, press and release the
“PROGRAMS” key while setting the hours: the
minutes value will flash.
9.
Press and release the UP or DOWN key within 15 s
to set the value of the minutes.
Operate as follows to set another switch-on day:
10.
Press and release the “PROGRAMS” key while
setting the minutes: the day value will flash.
11.
Repeat the 3 points... 9.
Operate as follows to exit the procedure:
12.
Hold the “PROGRAMS” key down for 1 s: the
DELAY LED will switch off.
Operate as follows to exit the procedure before the operation
is complete:
13.
Do not operate for 60 sec (any changes will not be
saved).
10.3
Enabling the "weekly
programmed switch-on"
function
Operate as follows to activate the "weekly programmed
switch-on":
1.
Make sure that the days and switch-on times and
the programs to start are set.
2.
Switch the device off by pressing the “ON/STAND-
BY” key for 1 s: the “DELAY” LED will flash, the
lower part of the “UPPER” display will show the
day and time of switch-on of the next weekly
programmed switch-on and the bottom part of the
“LOWER” display will show the number of the
program to start.
3.
Press and release the “UP” or “DOWN” key within
15 s to select a weekly programmed switch-on.
4.
Hold the “START/STOP” key down for 1 s within 15
s: the “DELAY” LED will remain on, the device
displays will show the switch-on day and time of
the next weekly programmed switch-on and the
number of the program to start and the device will
exit the procedure.
Setting the switch-on day and time and the program to start
Enabling the "weekly programmed switch-on" function