EVCO EVF328J9 - Manual (Page 26)

EVCO S.p.A. EVF 300 series | Installer manual ver. 1.1 | Code 144F300E114
Page 26 of 62
7. Hold the “PROGRAMS” key down for 1 s: the
device will leave the procedure.
Operate as follows to exit the procedure before the operation
is complete:
8. Do not operate for 15 sec (any changes will not be
saved).
9.3 Starting a program
Operate as follows to start a program:
1. Make sure that the device is on, that a cooking
cycle is not in progress and no procedure is in
progress.
2. Press and release the “PROGRAMS” key: the
bottom part of the “LOWER” display will show the
number of the first program used and the
remaining device displays will show the settings
memorised in the program; the program number
will flash.
If no program is used, the bottom part of the
“LOWER” display will show “-“ flashing and the
device displays will switch off.
3. Press and release the UP or DOWN key within 15 s
to select the number of a program.
4. Press and release the "START/STOP" key within 15
s: the number of the program will remain on with
fixed light and the program will be started.
Operate as follows to exit the procedure before the operation
is complete:
5. Press and release the “PROGRAMS” key or do not
operate for 15 s (the program will not be started).
9.4 Interruption of a program
Operate as follows to interrupt a program:
1. Make sure no procedures are in progress.
2. Hold the “START/STOP” key down for 1 s: the
buzzer will be activated for 3 s, the “TIMER” LED
will switch off and the bottom part of the “UPPER”
display will show “End” flashing for 3 s.
Starting a program