Comtrol PortVision DX User Manual
Page 91
PortVision DX User Guide
5.
, local or remote.
Note: The Device Status field is an informational field that displays the same status
displayed on the Main screen.
6.
Click the appropriate
•
Disable IP disables IP communications. Do not use this option unless you are going
to load the NS-Link device driver to run in MAC mode and not load any
DeviceMaster UP protocol.
•
DHCP IP to use the DeviceMaster UP with DHCP. Contact the Network
Administrator to provide the MAC address of the DeviceMaster UP and ask if you
should change the Subnet Mask, or Default Gateway values.
•
Static IP to program a static IP address and enter the appropriate values for your
site.
7.
After entering the changes, click Apply Changes.
8.
Click Close.
9.
After programming the network information, you need to verify that you have the
for your protocol loaded before performing any other configuration
procedures.
You can use the Web Interface tab to configure protocol settings or you can use the
feature. Optionally, you can modify protocol settings using the
familiar with the parameters.
Network Configuration
- DeviceMaster UP
91