Comtrol PortVision DX - Manual (Page 55)

PortVision DX User Guide
Buttons (Tools Menu) Descriptions
Undo Changes
The Undo Changes button only appears if you have loaded a
configuration file that contains settings different from those on the IO-
Link Master.
This selection reloads the protocol settings from the IO-Link Master and
the Apply Changes button disappears.
Save Settings to a File
Allows you to save the current configuration (protocol settings) of this
IO-Link Master in a file. All network and IO-Link Master (if applicable)
settings can be saved depending on your selections.
A Field Selection pop up appears so that you can select appropriate
configuration values. For example, you may not want the use the same
IP address.
Load Settings from a
File
Loads a previously saved IO-Link Master configuration file.
A Field Selection pop up appears so that you can select appropriate
configuration values.
After you load a configuration file to the Software Settings tab, make
sure that you review the differences that are displayed in green with an
asterisks before uploading the file to the IO-Link Master.
You must click Apply Changes before the changes are saved to the
IO-Link Master.
If the Apply Changes is not visible, the configuration file and IO-Link
Master contain the same settings.
Help Opens page-level help for this screen.
Close
Closes the window and queries you as to whether you want to save the
settings to a file or not if you made changes and did not click Apply
Changes.
You can disable this query using the Options... screen in the Tools
menu (Ask for confirmation on closing Properties screen item).
IO-Link Master Properties
55