Managing the devicemaster lt, Rebooting the devicemaster lt – Comtrol DeviceMaster LT User Manual
Page 69
DeviceMaster LT User Guide: 2000586
Rev. B
Managing the DeviceMaster LT - 69
Managing the DeviceMaster LT
This section discusses the following DeviceMaster LT maintenance procedures:
•
•
Updating Firmware Across WANs (Windows)
•
Uploading SocketServer to Multiple DeviceMaster LTs
•
Configuring Multiple DeviceMaster LTs Network Addresses
Note: You can configure the network addresses for multiple DeviceMaster LTs,
configure common settings for the DeviceMaster LTs, and save the
settings to a configuration file that you can use to load settings up to all
or selected DeviceMaster LTs.
•
Adding a New Device in PortVision DX
•
Using SocketServer Configuration Files
•
Using Driver Configuration Files
•
Changing the Bootloader Timeout
on Page 84, which discusses changing the
Bootloader timeout
•
on Page 85, which also discusses checking the
Bootloader version and downloading the latest Bootloader
•
•
Accessing SocketServer Commands in Telnet/SSH Sessions (PortVision DX)
Note: You can optionally refer to
on Page 99 if you want to
perform procedures at the RedBoot level.
Rebooting the DeviceMaster LT
There are many ways to reboot the DeviceMaster LT.
Optionally, you can power cycle the DeviceMaster LT.
Method
Procedure
PortVision DX
Right-click the DeviceMaster LT or DeviceMaster LTs in the
Device List pane, click Advanced >Reboot and then Yes.
Note: If security has been enabled in the web page, you will
need to reboot the DeviceMaster LT in the web page.
Web page
Main page (Server Status): Scroll to the bottom of the page,
click Reboot and then Yes: Reboot.
Telnet
Type reset.
DeviceMaster LT
DeviceMaster LT has a Reset/Restore switch.
•
If the Reset/Restore switch is depressed for less than 2
seconds, the DeviceMaster LT reboots.
•
If the Reset/Restore switch is depressed for greater than
approximately 5 seconds it restores the DeviceMaster LT
to the factory default values.