Comtrol DeviceMaster LT - Manual (Page 17)

DeviceMaster LT User Guide: 2000586 Rev. B Initial Configuration - 17
Installing PortVision DX
8. Depending on the operating system, you may need to click Yes to the Do you
want to allow the following program to install software on this computer?
query.
9. Click Launch PortVision DX and Finish in the last installation screen.
10. Depending on the operating system, you may need to click Yes to the Do you
want to allow the following program to make changes to this computer? query.
11. Select the Comtrol Ethernet attached products that you want to locate and
then click Scan.
Note: If the Comtrol Ethernet attached product is not on the local segment and
it has been programmed with an IP address, it will be necessary to
manually add the Comtrol Ethernet attached product to PortVision DX.
12. Go to Step 6 in the next section, Configuring the Network Settings, to program
the DeviceMaster LT network settings.
If you need additional information about PortVision DX, refer to the Help system.
You can save time if you only scan for DeviceMasters.