Brother FAX-2000P User Manual
Fax-2000p
Table of contents
Document Outline
- FAX-2000P
- Special Notice to User
- Precaurions
- How to Use this Manual
- Contents
- Getting Started
- Setting CIp YtMir Facsimile
- Preparing Ybar Facsimile
- Operation Panel
- Setting the Clock
- Storing Your Brother FAX ID
- Setting the Dialing Signal (Pulse/Tone)
- Setting the Reception Mode
- Tel Ready (Manual Reception)
- Fax Ready
- Tel/Fax Ready
- How to Store
- In standby mode, press FUNCTION, 0,5 and ENTER.
- Press ENTER.
- Enter an abbreviated number from the keypad, and press ENTER.
- a. When a number has not yet been stored, press ENTER to store a new number.
- b. When a number has already been stored, press CANCEL to change the number.
- Enter a facsimile number from the keypad, and press ENTER. Up to 40 digits can be stored including dashes {-), pauses, etc.
- How to Clear All Abbreviated Dials
- How to Print Abbreviated Dial List
- How to Clear All One-touch Dials (01-24)
- How to Print One-touch Dial List
- How to Set for One-touch Dials
- How to Clear All One-touch Program Keys Used as One-touch Dials
- How to Set a Communication Mode
- In standby mode, press FUNCTION, 1, 0 and ENTER.
- Press SELECT.
- Press ENTER.
- a. If the key has not yet been programmed, press ENTER for the newly programmed communication mode.
- The following communication modes can be ^' programmed:
- Press SELECT as required to call up the desired mode and press ENTER.
- When programming is finished, the control panel returns to the standby mode display.
- How to Clear Ail One-touch Program Keys for Communication Mode
- How to Print One-touch Program List
- Basic Operations
- Other CIsefal Basic Functions
- IKinsiiiission
- How to Cancel a Delayed Transmission
- How to Cancel Delayed Broadcasting
- How to Register a New Mailbox at the Receiving Side
- How to Edit Name and Key Number of Existing Maiibox
- How to Set Storage Time (Days) for Keeping Received Confidentiai Documents
- How to Print the Maiibox List
- How to Send Confidential Documents
- Mailbox Reception Notice
- How to Print out Received Confidential Documents
- Transmission Reservation and Interruption
- Sending Documents after Talking on the FAX Phone
- Polling
- Preparing Your FAX to be Polled
- Polling/Delayed Polling
- Sequential PoHing/Delayed Sequential Polling
- Confirmation and Cancaiiation of Timar-reiated Operation
- Confirming and Cancelling Hmer-relaled Operation
- How to Abort Broadcasting or Sequential Polling
- other Fonctions
- Setting ECM
- Closed User Group Communication
- Requesring Phone Communication
- Used as RS-232C Printer
- How to Set Parameters
- In standby mode, press FUNCTION, 0,9 and ENTER.
- Press 2, 4 and ENTER.
- Select data length, press SELECT to choose 7 or 8 bits, (normally, 7 bits). Then, press ENTER.
- Select parity bit. Press SELECT to choose NONE, ODD or EVEN. Then press ENTER.
- Select stop bit length. Press SELECT to choose 1 or 2 y bits. Then, press ENTER.
- How to Print Using the RS-232C Interface
- ASCII Code Table
- How to Set Parameters
- Optional Settings
- Parameters for Dialing and Ringing
- Parameters for Recording (Printing) Unit
- Printing the Machine Settings
- Ihxibleshooting